We used a dremel to cut out the holes for the vents, *very nerveracking*, and
I added 2 pieces to the frame for support (the 2 vertical pieces closest to each side of the vent area), and made 2 notches in the vertical pieces for the data port to fit.
We altered the frame again for the vent to fit in as you can see.
And after much sanding we got the vents to fit in!
Picture of vent, still not finished of course, but will be soon!
(close up of vent)
And below is the glue we used to glue the vent inserts to the vent surround. (TesTors cement for plastic models)
More leg progress:
Totally not related, but anyway,
Here is my dad's (Calvin) light up movie poster finally finished and mounted on the wall:
No comments:
Post a Comment